Manual [patched]: V2000-c User

Ensure there is at least 3 inches of clearance for ventilation and wiring. Basic Wiring Diagram Connect the DC power supply to the designated +/−positive / minus terminals.

Yes. Locate the pinhole reset on the bottom panel. With the unit powered on but idle, press and hold the reset button using a paperclip for 15 seconds. The device will restore factory defaults, including clearing the password. Warning: This erases all custom profiles. v2000-c user manual

Navigate to the 'Users' tab to enroll card numbers and assign access levels. Ensure there is at least 3 inches of

The is a standalone RFID access control keypad designed to secure single-door entrances. It supports authentication through 125KHz RFID cards, 4-digit PIN codes, or a combination of both. Key Technical Specifications User Capacity : Supports up to 1,000 users. Operating Voltage : 12VDC ±plus or minus Card Type : Compatible with 125KHz EM standard cards. Locate the pinhole reset on the bottom panel

* [Admin Code] # → 7 → [Scan Card or enter Card ID] → # * [Admin Code] # → 2 → [00–99 seconds] → # Delete All Cards * [Admin Code] # → 86 (on specific YH/V models) Wiring Instructions Ensure power is disconnected before wiring to avoid damage. Red: +12VDC Power Supply. Black: GND (Negative).